No mention of the camera make, but my guess it's one of the new Point and Stab models!
http://www.myrtlebeachonline.com/2012/0 ... ge-nc.html
Dusty
I wonder the camera make
- Dusty
- Emperor of a Minor Galaxy
- Posts: 2215
- Joined: Thu Dec 18, 2008 5:04 pm
- Location: Ironton, Missouri, USA
I wonder the camera make
An a700, an a550 and couple of a580s, plus even more lenses (Zeiss included!).
- Greg Beetham
- Tower of Babel
- Posts: 6117
- Joined: Sun May 27, 2007 3:25 pm
- Location: Townsville, Qld. Australia
- Contact:
Re: I wonder the camera make
Yeah don't you hate that when someone does that....but stabbing them though might be a bit extreme.
Greg
ps there was a show on TV last nite called 'a thousand ways to die,' it was basically real footage and re-enactments of fatal accidents people had and it was graphic indeed. One was a guy who got run over by a semi (only moving slowly in a parking lot area) the driver didn't see the guy half under his own vehicle fixing the muffler and ran over the lower half of his body. The footage showed the guy screaming with no body basically from just above the pelvis down that had been separated off. He still lived for another three hours afterwards and apparently two ambulances arrived but the body parts ended up at two different hospitals and they took too long to sort that out.
Greg
ps there was a show on TV last nite called 'a thousand ways to die,' it was basically real footage and re-enactments of fatal accidents people had and it was graphic indeed. One was a guy who got run over by a semi (only moving slowly in a parking lot area) the driver didn't see the guy half under his own vehicle fixing the muffler and ran over the lower half of his body. The footage showed the guy screaming with no body basically from just above the pelvis down that had been separated off. He still lived for another three hours afterwards and apparently two ambulances arrived but the body parts ended up at two different hospitals and they took too long to sort that out.
Who is online
Users browsing this forum: No registered users and 58 guests