Wirelss Flash Networking Questions (Sony a100)
Posted: Sun Jun 29, 2008 9:29 pm
First off, a history.
I've a Minolta Dynax Maxxum 9xi for about 10 years now, and use 5400hs flash units, where you can wirelessy network mulitple flashes.
I bought two additional 5400hs flash units recently, only to find that they don't effectively use wireless on the Sony Alpha 100, and can only be used singly, and at full/manual strength.
So, I want the same 'two-remote flashes, one-on-camera flash' for my Sony a100 (digital) as I do my Minolta 9xi (35mm.)
I looked into the Sony HVL-F36AM, but some reviews point out that it can't be used as a Master Controller.
I then looked into the Sony HVL-F56AM, which CAN be used as a Master Controller, but is also very expensive.
Finally, I found flashes like the Phoenix d92-bzs, which are cheap, and, I think, use the actual flash coming off of the main camera as a cue to flash themselves... whether or not this would be a problem for me, or for the Sony a100, I cannot say.
So, any experiences?
Do I buy a HVL-F56AM, and use two Phoenixes to get that on-camera-flash and two satellite flashes I want? Can I use the HVL-F56AM as a Master Controller for the two Phoenixes, or not? Can I use the factory-on-camera flash, and use two Phoenixes? Can more than one Phoenix be used, or will it get confused, since it's not the same kind of wireless networking as if all three were Sony units?
Results? Suggestions?
I understand there's issues with distances and strengths in lower-priced flashes, but I also balance that with changing the flashes' distance from the subject, bouncing the flashes, bounce-heads, diffusers, etc.
Please, give me some experiences, suggestions, and ideas on how to get my three-point flash system back on my Sony a100!
Thank you! (bolded words for quick reference when replying)
I've a Minolta Dynax Maxxum 9xi for about 10 years now, and use 5400hs flash units, where you can wirelessy network mulitple flashes.
I bought two additional 5400hs flash units recently, only to find that they don't effectively use wireless on the Sony Alpha 100, and can only be used singly, and at full/manual strength.
So, I want the same 'two-remote flashes, one-on-camera flash' for my Sony a100 (digital) as I do my Minolta 9xi (35mm.)
I looked into the Sony HVL-F36AM, but some reviews point out that it can't be used as a Master Controller.
I then looked into the Sony HVL-F56AM, which CAN be used as a Master Controller, but is also very expensive.
Finally, I found flashes like the Phoenix d92-bzs, which are cheap, and, I think, use the actual flash coming off of the main camera as a cue to flash themselves... whether or not this would be a problem for me, or for the Sony a100, I cannot say.
So, any experiences?
Do I buy a HVL-F56AM, and use two Phoenixes to get that on-camera-flash and two satellite flashes I want? Can I use the HVL-F56AM as a Master Controller for the two Phoenixes, or not? Can I use the factory-on-camera flash, and use two Phoenixes? Can more than one Phoenix be used, or will it get confused, since it's not the same kind of wireless networking as if all three were Sony units?
Results? Suggestions?
I understand there's issues with distances and strengths in lower-priced flashes, but I also balance that with changing the flashes' distance from the subject, bouncing the flashes, bounce-heads, diffusers, etc.
Please, give me some experiences, suggestions, and ideas on how to get my three-point flash system back on my Sony a100!
Thank you! (bolded words for quick reference when replying)