Hi.
I have an a900 and a 58am as a controller. I have a refitted 5400HS, that normaly work fine both as single on-body-flash, and as wireless flash. But when i want to set a ratio between controller and the slave, i cant seem to get it work. Either the controller or the slave over expoces. Have any of you any experiens with this setup?
Sorry for the bad english..
Regards
Michael
Ratio in wireless falsh setup's
- Greg Beetham
- Tower of Babel
- Posts: 6117
- Joined: Sun May 27, 2007 3:25 pm
- Location: Townsville, Qld. Australia
- Contact:
Re: Ratio in wireless falsh setup's
Michael what do you mean by a 5400HS 'refitted' ? I don't have a F58 myself, but I thought it was the first that could do ratio in the late model flashes, but I thought it needed to work with another F58, I'm not totally sure though. My F56 (5600HSD) can't do it, it says in the handbook that the ratio that is listed on the rear screen is inoperative and not to use it. Btw I thought with two flashes you just use the WL (you will need a third flash for the A900, no flip-up flash) feature and play around with the distance from the subject with the remote flashes.
Greg
Greg
Re: Ratio in wireless falsh setup's
Hi Greg.
Thx for your advice/opinion. I have refitted the MINOLTA 5400HS with a PCB, so that i can work with my a900. Otherwise it just goes FULL flash every time.
Thx for your advice/opinion. I have refitted the MINOLTA 5400HS with a PCB, so that i can work with my a900. Otherwise it just goes FULL flash every time.
Who is online
Users browsing this forum: No registered users and 5 guests